shielded cable cervipar pos 500v cpr

Flexible instrumentation and control cable for analog or digital signal transmission and control of industrial equipment, when protection against electrical noise is required.

See only CPR
See by cable type
See by fire behaviour

If you need technical support complete the form or call us at (+34) 937 362 730

Support
Shielded Cable CERVIPAR POS 500V CPR
~\ImgCli\FOTO2_196.jpg
Flexible instrumentation and control cable for analog or digital signal transmission and control of industrial equipment, when protection against electrical noise is required.
Protegido electromagneticas
No propagador de la llama
Flexible
Construction
1. Conductor
Flexible bare copper wires
Class V Acc. to UNE-EN 60228
2. Insulation
PVC (Type TI51)
Identification: Blue + Black numbered
3. Composition
Two conductors insulated twisted forming a pair
4. Assembly
Wired pairs in concentric layers
5. Overall screen
Polyester tape separator
Alu/Polyester Tape + tinned copper wire drain
6. Outer sheath
PVC (Type TM51)
Colour standard: Black
Technical characteristics
1. Operating voltage
500V
2. Test Voltage
2000V
3. Operating Tª (conductor)
Instalación fija: -15°C a +70°C
During installation: 0°C Minimum
Shortcut (Max. 5 seg): 160°C
4. Min. bending radius
Normal service:
4xD (Diameter up to 8 mm)
5xD (Diameter up to 12 mm)
6xD (Diameter > 12 mm)
5. Insulation resistance
10 MOhm*Km Min
6. Mutual capacitance
<250 nF/Km
Standards
1. Design
According EN 50288-7
2. CPR Classification (Euroclass)
Eca
(According UNE-EN 50575)
3. Flame Retardant
UNE-EN 60332-1 (IEC 60332-1)