screened cable cervipar par pos 500v cpr

Flexible instrumentation and control cable for transmission of analog or digital signals and control of industrial equipment. With individual screen on each pair in addition to the general one, especially suitable when protection against electrical noise is required.

See only CPR
See by cable type
See by fire behaviour

If you need technical support complete the form or call us at (+34) 937 362 730

Support
Screened Cable Cervipar PAR POS 500V CPR
~\ImgCli\FOTO2_197.jpg
Flexible instrumentation and control cable for transmission of analog or digital signals and control of industrial equipment. With individual screen on each pair in addition to the general one, especially suitable when protection against electrical noise is required.
Protegido electromagneticas
No propagador de la llama
Flexible
Technical characteristics
1. Operating voltage
500V
2. Test Voltage
2000V
3. Min. bending radius
Standard service:
5xD (Diameter up to 12 mm)
6xD (Diameter > 12 mm)
4. Operating Tª (conductor)
Fixed installation: -15°C a +70°C
During installation: 0°C Mínimo
Short-circuit (Max. 5 seg): 160°C
5. Insulation resistance
10 MOhm*Km Min.
6. Mutual capacitance
<250 nF/Km
Construction
1. Conductor
Flexible bare copper wires
Class V Acc. to UNE-EN 60228
2. Insulation
PVC (Type TI51)
Identification: Blue + Black numbered.
3. Assembly
Individual screened pairs laid up in concentricall layers
4. Composition
Two insulated conductors twisted together as a pair
5. Overall screen
Polyester tape +
Aluminium/Polyester tape + tinned copper drain wire
6. Individual screen
Polyester tape +
Aluminium/Polyester tape + tinned copper drain wire
7. Outer sheath
PVC (Type TM51)
Standard colour: Black
Standards
1. CPR Classification (Euroclass)
Eca
(According to standard UNE-EN 50575)
Standards / Properties
1. Flame Retardant
UNE-EN 60332-1 (IEC 60332-1)
2. Ref. standard for drawing
Based on EN 50288-7